DuraGlow - No More Deadsticks

[RC-Warbirds]

Made in Singapore: DuraGlow
Kiss Dead Sticks goodbye with this affordable on-board Glow Driver.

DuraGlow S is an affordable on-board Glow driver for Glow/Nitro RC Engines of all sizes. The adjustable idle point allows precise setting of glow on/off position in relation to throttle position. An integrated LED shows when the glow driver gets activated to further ease the initial setup and provide ways of checking the glow during operation.
The DuraGlow S is either connected via a Y-Cable to the throttle channel or mixed with the help of a separate channel to the throttle input allowing it to be switched on and off via the remote.
Suitable for single or multi engine operation the DuraGlow is your insurance policy for reliable engine operation (especially important for multi engine operation).
The DuraGlow can also be used as simple on/off switch for lights, brush motors, pumps and release mechanisms.

How Does It Work?
DuraGlow S is an electronic switch that monitors the throttle position of your RC engine. Once it detects a throttle position below or above a user set position it will switch power to the glow/nitro engines glow plug lighting it up.
DuraGlow uses a separate battery and isolated circuit inside the model to power the glow plug hence eliminating any interference cause by voltage drops or engine operation.

Benefits:
- Improves operational safety by eliminating the need to unplug a glow driver after the engine has been started.
- Improves engine reliability as glow plug is heated even if the engine RPM drops.
- Reduces min possible idle RPM by heating the glow plug automatically
- Reduces engine tuning time
- Might improve health through cutting down of dead sticks and therefore reducing pilot stress levels (especially true for multi engine planes)

VISIT OUR WEBPAGE FOR MORE INFORMATION !! http://www.rc-warbirds.com/product_i...roducts_id/611