T E A M
Hi there, need your advise. I have just brought a 6 ch feigao rx + feigao cystral. Knowing that it has a lot of problem (after reading the forum), I don't know where to plug the rx battery. It has 6 slot for servo, but where to insert the battery, I don't want to blow it because of my silly mistake. Thanks.
-
-
You flying electric or gas???
For electric,
The battery plugs into the esc and then the esc is connected to channel 3 of the rx....
at least that is how i do it....
For gas flyers... hmm... i not too sure.. normally the battery is connected directly to channel 6 ?? But i am not too certain...
Last edited by dabiddo; 08-11-2004, 09:29 PM. -
try not to plug directly into the rx.Comment
-
is ur rx batt a 5v one? if so, u can plug it into the + and - terminal of the rx. just make sure u plug it in the correct way.
Failure is not final,
Success is never ending:
It is not the destination but the journey that matters.
Wadever the journey, keep flying!Comment
-
Thanks for the advised. I'm currently flying gas, therefore the Batt is directly insert into the receiver. Didn't know that it works different from electric.Comment
-
Just FYI, the outside pins are negative.
So you should know what to do
-Feda Dragonfly
-Hornet 2
-Pilot OK Turmeric
-Zoom Zoom 4D
-Sceadu EVO 50: OS50, Hatori521, Revmax,
-Hornet X3D
-Hornet X3D (yet to setup!)
-Formosa 1
-World Models Spot On 50
-HB King 2
-World Models Groovy 50 F3A
-RICCS F18 EDF
Controlled by 9CHP
(Temasek Poly AMIG)Comment
-
and middle the red wire
Do a range check b4 u fly pleaseTX:2 Sanwa Quasars , Futaba 9C super (heli)
Gliders :JW 54 , Sprinter , Flip400 (unbuilt)
Planes: Jumping Jack,,Zoom 4D,IFO, magic 3d,
Helis:Feda,Zap 400Comment
Comment